Zilog ZUSBOPTS Manual do Utilizador descarregar pdf (Página 88)

100

101

Menu Bar UM017105-0511

Zilog Developer Studio II – ZNEO™

User Manual

for a discussion of the ZNEO address spaces) except for a particular module that is to be

run from the RAM (16-bit addressable RAM) space. See the Special Case: Partial Down-

load to RAM section on page 317 for an example of how to configure the linker command

file for this type of application.

It is the user’s responsibility to configure the linker command file properly when the Dis-

tinct Code Segment for Each Module checkbox is selected.

Default Type of Char. The ANSI C Standard permits the compiler to regard char vari-

ables that are not otherwise qualified as either

signed or unsigned, at the compiler’s

discretion; the compiler is only required to consistently apply the choice to all such vari-

ables. So in the following declarations:

signed char sc;

unsigned char uc;

char cc;

the signedness of cc is left to the compiler. The Default Type of Char drop-down menu

allows you to make this decision. The selection,

Signed or Unsigned, is applied to all

char variables whose signedness is not explicitly declared. The default value for ZNEO is

Unsigned.

Project Settings—Librarian Page. This page is available for Static Library projects only.

To configure the librarian, observe the following procedure:

1. Select

Settings from the Project menu. The Project Settings dialog box is dis-

played.

2. Click the

Librarian page.

3. Use the

Output File Name field to specify where your static library file is saved.

Project Settings—Commands Page. Figure 56 shows the Commands page.

Note:

1 2 ... 83 84 85 86 87 88 89 90 91 92 93 ... 519 520

Comentários a estes Manuais

Sem comentários

Zilog ZUSBOPTS Manual do Utilizador Página 88

Comentários a estes Manuais

Manuais e produtos relacionados com Sensores Zilog ZUSBOPTS