Zilog ZUSBOPTS Manual do Utilizador descarregar pdf (Página 119)

100

101

UM017105-0511 Menu Bar

Zilog Developer Studio II – ZNEO™

User Manual

d. Click Read Serial to check the serial number for the current device.

17. Program the Flash memory by clicking one of the following buttons:

– Click

Program to write the hex file to Flash memory and perform no checking

while writing.

– Click

Program and Verify to write the hex file to Flash memory by writing a seg-

ment of data and then reading back the segment and verifying that it has been

written correctly.

18. Click

Verify to verify Flash memory. The Flash Loader reads and compares the hex

file contents with the current contents of Flash memory. This function does not change

target Flash memory.

Firmware Upgrade

This command is available only when a supporting debug tool is selected (see the Debug

Tool section on page 80).

•

USB Smart Cable

\bin\firmware\USBSmartCable\USBSmartCa-

ble upgrade information.txt

•

Serial Smart Cable

This product is not available for this release.

•

Ethernet Smart Cable

\bin\firmware\EthernetSmartCable\Ether-

netSmartCable upgrade information.txt

Show CRC

This command is only available when the target is not a simulator.

Observe the following procedure to perform a cyclic redundancy check (CRC):

1. Select

Show CRC from the Tools menu. The Show CRC dialog box is displayed; see

Figure 72.

Note:

1 2 ... 114 115 116 117 118 119 120 121 122 123 124 ... 519 520

Comentários a estes Manuais

Sem comentários

Zilog ZUSBOPTS Manual do Utilizador Página 119

Comentários a estes Manuais

Manuais e produtos relacionados com Sensores Zilog ZUSBOPTS