Zilog ZUSBOPTS Manual do Utilizador descarregar pdf (Página 104)

100

101

Menu Bar UM017105-0511

Zilog Developer Studio II – ZNEO™

User Manual

Target. Select the appropriate target from the Target list box.

Setup. Click Setup in the Target area to display the Configure Target dialog box; see

Figure 61.

The options displayed in the Configure Target dialog box depend on the CPU you selected

in the

New Project dialog box (see the New Project section on page 32) or the General

page of the

Project Settings dialog box (see the Project Settings—General Page section

on page 47). Chip select and external bus interface settings are only available for CPUs that

support an external bus.

1. Select an 8-bit, 16-bit, or no external bus interface. Selecting an external bus interface

is appropriate only for target designs that use an external bus.

2. If an external bus interface is selected, do the following steps for each chip select that

is used by the target system for external memory or I/O. The settings appropriate for

each chip select depend on the target system design.

a. Choose the chip select register (CS0–CS5) from the

Chip Select Registers drop-

down menu.

b. Select the

Enabled checkbox to enable the chip select. Do not enable chip selects

that the target does not use.

Figure 61. Configure Target Dialog Box

Note:

1 2 ... 99 100 101 102 103 104 105 106 107 108 109 ... 519 520

Comentários a estes Manuais

Sem comentários

Zilog ZUSBOPTS Manual do Utilizador Página 104

Comentários a estes Manuais

Manuais e produtos relacionados com Sensores Zilog ZUSBOPTS