Zilog ZAURCT Manual do Utilizador descarregar pdf (Página 16)

UM022903-0311 ZAURA System Installation and Configuration

ZAURA

™

RF Wireless Lighting Control

Installation Guide

a. Set the Master type switch to the Standard (OFF, OFF) position.

b. Make sure the mode is set to Normal Operation (i.e., DIP switches 1, 2 and 3 are

in the OFF position).

c. Set the turn-off delay to the required value (the recommended setting is 5 min-

utes).

d. Adjust light and movement sensitivity, if required. For additional assistance with

this step, see the the Occupancy Detection Adjustment

section on page 22 and the

Light Detection Adjustment

section on page 23.

e. Install one battery. For additional assistance with this step, see the Install Batteries

section on page 24.

6. Configure the Range Extenders (if required). For additional assistance with this step,

see the Configuring ZAURA Range Extenders

section on page 33.

a. Set the Master type switch to Range Extender (OFF, ON) position.

b. Set DIP switches 1 through 8 to match the Master.

c. Adjust the Occupancy sensitivity POT, if required.

d. Install the batteries.

e. Associate the Range Extender(s) to the appropriate Master.

7. Set the Virtual Dimming Luminaries (if no Virtual Dimming luminaries are required,

skip to Step 8). For additional assistance with this step, see the Set Up and Install

ZAURA Virtual Dimming Luminaries section on page 26.

a. Replace the original starters with ZAURA Starters.

b. Associate the ZAURA Virtual Dimming Starters to the Master.

c. Verify the association of all ZAURA Virtual Dimming Starters.

8. Set the Standard Luminaries to be controlled by the Master. For additional assistance

with this step, see the Set Up and Install ZAURA Standard Luminaries

section on

page 29.

a. Replace the original starters with ZAURA Starters in the remaining luminaries to

be controlled by the Master.

b. Associate ZAURA Starters to the Master. For additional assistance with this step,

see the Associating a ZAURA Starter with a Master

section on page 30.

c. Verify association of all ZAURA Starters.

9. Mount the Master to the previously installed base plate closest to the center of the

room. Mount the Range Extenders (if any) to their designated base plates. For

additional assistance with this step, see the Mount Master/Range Extenders

section on

page 31.

10. The room is complete.

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 ... 58 59

Comentários a estes Manuais

Sem comentários

Zilog ZAURCT Manual do Utilizador Página 16

Comentários a estes Manuais